home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Netware Super Library
/
Netware Super Library.iso
/
app_note
/
tecbltn1
/
tb.146
< prev
next >
Wrap
Text File
|
1986-08-28
|
2KB
|
46 lines
/nof
Number: 146 Date: August 16, 1986
Title: (Novell) NetWare ARCNET NIC Support.
By following the directions below the (Novell) NetWare ARCNET NIC
can be used with all versions of NetWare and Advanced NetWare from
4.54 through 2.01. This board can be used in place of the Standard
Microsystems ARCNET card in any NetWare/SM or Advanced
NetWare/SM applications.
For NetWare/SM verisons 4.54 through 4.61b only:
Using the manual set the board to IRQ-2, I/O port 2E0 and base
memory D000. If the board is to be used in the server it must
be set to physical node address 01. Workstation boards are set
to a unique address other than 01. IRQ-2 is not used on
workstation boards and can be disabled by following the supplied
documentation.
For Advanced NetWare versions 1.0 through 1.02a only:
Using the manual, set the board to IRQ-2, I/O port 2E0 and
base memory D000. Servers and stations on the ARCNET system
MUST all be set to unique physical node addresses. Versions
1.0 through 1.01a did not use any interrupts on the
workstations. You may therefore disable the interrupt. On
version 1.02 and 1.02a IRQ-2 MUST be enable on the stations as
well.
For Advanced NetWare V2.0, V2.0a and V2.01 only:
The drivers, on the diskette which is shipped with the (Novell)
NetWare ARCNET NIC, are for use only with Advanced NetWare
version 2.0, 2.0a or 2.01. They are NOT to be used with prior
versions. Previous versions contained the appropriate driver in
the software.
For Advanced NetWare versions 2.0, 2.0a and 2.01, follow
instructions supplied with the manual and the diskette. Please be
aware of the important information explained in the manual
concerning physical node address selection. (The (Novell)
NetWare ARCNET NIC physical node address selection is
different than the selection for the board supplied by Standard
Microsystems.)
/for